最新なJuniper JN0-692問題集（60題）、真実試験の問題を全部にカバー！

質問 1：
You are monitoring the control plane traffic using a network analyzer on an Ethernet network segment with all routers configured with IS-IS routing. Which two statements are true? (Choose two.)
A. DIS will send hellos more frequently than other IS-IS devices.
B. PSNPs are sent periodically.
C. Only the DIS will send CSNPs periodically.
D. L1 and L2 hellos are combined in a single hello packet.
正解：A,C

質問 2：
Click the Exhibit button.
user@router> show route 100.1.1.0
inet.0: 17 destinations, 19 routes (16 active, 0 holddown, 0 hidden)
+ = Active Route, - = Last Active, * = Both
100.1.1.0/24 *[BGP/170] 00:08:51, localpref 100
AS path: 65000 I
to 17.3.1.4 via xe-5/2/0.0
> to 17.1.1.1 via xe-5/2/1.0
[BGP/170] 00:08:51, localpref 100
AS path: 65000 I
> to 17.3.1.4 via xe-5/2/0.0
Referring to the exhibit, which configuration was used to load-balance traffic across xe-5/2/0 and xe-5/2/1 interfaces?
A. set protocols bgp group CUST advertise-inactive
B. set protocols bgp group CUST metric-out igp
C. set protocols bgp group CUST multihop
D. set protocols bgp group CUST multipath
正解：D

質問 3：
Click the Exhibit button.


A customer is not seeing direct routes in the LDP database.
Referring to the exhibit, which configuration is required on router R2 to advertise labels corresponding to direct routes?
A. set protocols ldp igp-synchronization
B. set protocols ldp egress-policy connected-routes
C. set protocols ldp export connected-routes
D. set protocols ldp import connected-routes
正解：B

質問 4：
Click the Exhibit button.
-- Exhibit -
pim { spt-threshold { infinity mcast; } rp { static { address ; } } interface ge-0/0/0.0 { disable; } interface ge-0/0/3.0; interface ge-0/0/4.0;
}
policy-statement mcast { term 1 { from { route-filter 224.0.0.0/4 orlonger; } then accept; }
}
-- Exhibit -
Referring to the last-hop router's information shown in the exhibit, multicast flows are using a suboptimal path. What is the reason?
A. RPF is failing for the entire multicast range.
B. All flows are traversing the rendezvous point because of the configuration.
C. The SPT policy is using the wrong subnet mask for the multicast range.
D. All flows are switching over to SPT too fast.
正解：B

質問 5：
Click the Exhibit button.

You have been asked to establish an IPv6 EBGP peering between R1 and a customer's router. You have an existing IPv4 EBGP peering to this device. After adding the IPv6 neighbor configuration to the existing EBGP group configuration, the IPv4 neighborship is down and will not establish.
Referring to the exhibit, what should you do to resolve this problem?
A. Move the inet6 unicast statement to the global BGP hierarchy.
B. Enable the inet unicast NLRI for this neighbor.
C. Change the order of the neighbor configurations so IPv6 is first.
D. Change the inet6 NLRI configuration to use any instead of unicast.
正解：B